A swivel connector allows you to connect the Shower Power Booster directly to 3/4” Male BSP Thread.

Step 1

Take the bush from the reducing set supplied and insert into the body of the pump.

Step 2

Place a washer on the bush and connect the round end of the swivel connector, creating a seal.

Step 3

Place second washer inside the 3/4” swivel nut. The Shower Power Booster is ready to connect to a 3/4” Male BSP Thread.

A 15mm or 22mm slip coupling can be used if you need some play on the pipes to fit the Shower Power Booster.

Step 1

Cut the pipe either side of where you want to fit the pump.

Step 2

Install the pump on the length of pipe you have removed.

Step 3

Reinstall the length of pipe you have removed.

The coupling simply slips over the pipe so you can easily reconnect when the pump is installed.

3 Piece Reducing sets are supplied with all Shower Power Booster meaning you can easily install the pump on either 22mm or 15mm pipe. When installing on 15mm pipe you need to use the 3 piece reducing set.

Step 1

Remove 22mm Nut & Olive.

Step 2

Insert the Bush, thin end first.

Step 3

Insert the 15mm Olive.

Step 4

Place Ring on Olive, with the lip resting on the 15mm Olive.

Step 5

Put the 22mm Nut back on and tighten.